30 Notebook Storage Cart

30 Notebook Storage Cart

30 COMPUTERS // Stores and charges up to 30 notebook computers
30 HORIZONTAL COMPARTMENTS // Three columns of 10 compartments, each with its own electrical access
30 OUTLETS FRONT OR REAR // Two overload-protected UL-Listed, 15-outlet units which can be ordered in the front or the rear of the cart
AUTOMATIC TIMER // Due to electrical limitations, each 15-outlet electrical unit must be plugged into separate circuits and not separate outlets OR use the LAPTMR to automatically switch from charging one bank of computers to the other
SECURITY // Resettable combination padlock included

ASSEMBLED 30 COMPUTER NOTEBOOK CART
Entire cart shall be completely welded together. Cart shall have one 42-1/2"W x 24"D, 18-gauge steel work surface shelf which shall have two 2" diameter grommet holes in rear of shelf. The underside of the work surface shall have one 18-gauge stiffener with two 28.5mm holes for use with an optional security cable. Work surface shall be covered with black rubber mat. Cart shall also have one 42-1/2"W x 24"D, 18-gauge steel bottom shelf and nine 42-1/4"W x 17"D, 18-gauge interior shelves. Interior shelves shall have 2 x 2 cutouts in rear corners to aid in cord management. Each laptop compartment shall measure 12"W x 17"D x 3"H. Interior shelves shall attach to side and back panels by support tabs. Also enclosed shall be two, 20-gauge outer panels and two, 20-gauge inside panels. Cart shall have one, 20-gauge back panel. Back panel shall have two 2" diameter grommet holes and a cut out for an automatic timer located at the bottom rear and on outside back panel there are two cord winders for cord management. Cart shall have two, 20-gauge doors that shall have multiple-point locking system with re-programmable, three-dial combination padlock to lock doors. All panels shall have ventilation holes throughout. Legs shall be 18-gauge 1" square tubular steel. Unit shall have four 5" plate casters, two rigid and two swivel with locking brakes. Cart shall have built-in handles. Each model shall be painted in grey powder coated paint. Overall dimensions shall be 42-1/2"W x 24"D x 47-5/16"H. Unit shall have two, 15-outlet electrical units. Electrical units shall be installed inside the front or back of the cart. Each unit is UL listed, surge protected, shall include a 20' power cord, and has an on/off switch located at the base. When using both electrical units at the same time, each unit must be plugged into outlets on separate electrical circuits to prevent the overload and tripping of the circuit breaker. UL-Listed cart includes an automatic timer.